As a heating method for RHCM (Rapid Heating Cycle Molding) various heating technologies such as high frequency induction heating, IR heating, gas heating, and high temperature steamare applied, but these methods are not satisfying high productivity due to low energy efficiency. Research has been actively conducted on RHCM based on planar heating elements with high heating efficiency, such as carbon nanotubes, which are applied. To apply the CNT web film to the RHCM, a heating element must be applied inside the injection mold and power must be applied. As electricity is directly applied to the CNT web film to generate heat, all mold parts in contact with the CNT web film must be insulated, and high heat transfer is required for rapid heating performance. Thus, in this study, a multi-layer structure mold module for insulation and high heat transfer was designed to enable rapid heating by applying a CNT web film as a heat source. To this end, we intend to present a research direction for the commercialization of rapid heating molds, by identifying the main variables of rapid heating through heating experiments by the mold metal and insulator materials, and reflecting them in the mold design.

Injection molding is one of most widely-used polymer processing technologies in which hot polymer fills a mold cavity, and is solidified during the subsequent cooling process. In the mold filling stage, the mold temperature should be high to improve flow characteristics, and low to reduce cooling time during the cooling stage. To fulfill these objectives, rapid mold heating technology has been developed to raise mold temperature, without significant increase in cycle time. While the conventional rapid heating technologies required dedicated facilities such as steam heating or high-frequency induction heating system and has a limitation in uniform heating, the purpose of this study was to develop a facile and conformal mold heating unit that uses a carbon nanotube (CNT) film heater. The CNT film heater was used to heat a curved mold with high temperature uniformity, by maintaining uniform distance from the mold surface. The developed conformal heating technology was then applied to a singly curved mold and a multiply curved mold. Considering that the resulting temperature uniformity is superior to the conventional oil heating, the conformal mold heating technology using the CNT film heater can be used to improve part quality and productivity in various molding processes.

The design of the injection mold cooling system is important. The cooling time consumes 70-80% of the injection molding cycle, so a well-designed cooling system can shorten the molding time and improve productivity significantly. Recently, many studies have been conducted for rapid cooling of a hot-spot area using CO₂ in injection molding. In this study, a cooling module based on CO₂ was designed and manufactured for uniform and rapid cooling of an injection mold with a large cavity, and cooling characteristics were investigated through experiments. As the CO₂ supply pressure increased, the cooling effect increased significantly, while the cooling uniformity decreased relatively. In the case of using the heat exchanger, the cooling effect increased by 10oC on average compared to the case without the heat exchanger, whereas the effect on the cooling uniformity was insignificant. When the CO₂ was injected from both sides, the cooling effect increased by approximately 8oC on average compared to the case of injection from one side, and the cooling uniformity was approximately 10% higher. By using a heat exchanger and applying CO₂ bidirectional supply, a cooling rate of up to 5.78℃/s and an average of 4.9℃/s could be achieved.