Induction heating is a technology that uses heat generated by resistance when a high-frequency current is applied to a coil. An electric range using this is called an Induction Heating (IH) electric range. IH electric ranges are being widely applied in commercial products recently because they have higher thermal efficiency performances than other methods. The performance of a heating coil of an IH electric range greatly varies depending on the shape and number of coils. Thus, research on optimal coil shape and number according to product shape is required. Therefore, this study aimed to design an optimal heating coil at the set temperature of an electric range product. Target temperature was set to the temperature that a commercial stainless-steel container could withstand. The thickness of the coil copper wire, the number of windings, the applied voltage, and the frequency were set as design variables. A sensitivity analysis was performed to check the influence of each design variable on coil temperature. Based on this, optimal design was performed using the response surface method. Electromagnetic field-thermal analysis was performed with the designed coil and a very approximate result was obtained with a 0.07% error from the set target temperature.

Complex parts are manufactured with high production rates using plastic injection. Defects in injection moulded parts are typically caused by non-uniform cooling. The design of cooling channels is a key step in the mould tool design process. Laser sintering allows for the direct fabrication at reasonable price, complex 3D tools with integrated cooling channels without the need of fixtures. This technique allows the designer to optimise the position of cooling channels relative to the heat source. This paper presents a simulation study for a non-constant thickness threaded screw cap. Results comparing conventional to conformal cooling channel show that the range between the highest and the lowest part surface temperatures is reduced by 18.8%. On the other hand, there is only a decrease of 3.9% for the maximum temperature in the interior of the threaded screw cap. Conformal cooling using laser sintering in tool manufacturing achieves an improved heat transfer leading to a better part quality.